BLUETTI EB150 is equipped with 1500Wh lithium power storage(Top-Brand Lithium Polymer Battery Cell, ,101351mAh/14.8V(equivalent to 405405mAh 3.7V), and with a large AC inverter 1000W, this Power Station is specially designed for high-power device such as blender, Drill, hair Dryer(Max.1000W,above 1200W will turn off) it meets various kinds of power needs and widely used for home use, outdoor activities, RV, etc.
We built in BMS(battery management system), it has over-load/ over-current/ over-temperature/ over voltage/ low-voltage/short circuit protection.
Strict QC control and top Components ensure the quality and safety.
The EB150 can power up to 8 devices simultaneously.
2 * 220V-240V AC outlets (Pure sine wave) for most household appliance under 1000W Such as blender,TV, household dryer,laptops.
1 * regulated DC12V 9A for car devices like mini-fridge, car vacuum cleaner.
1 * 45W Type-C for USB-C devices such as Laptop MacBook/MacBook Pro & PD Type-C Phones.
4 * 5V 3A(Max) USB for phones, tablets,camera,fans,light and more,Keep multi daily-used devices running in case of unexpected power failure or away from a wall outlet,widely used indoor or outdoor.
AC Inverter: Max.1000W(continuous),load 1000w~1200W last for 2mins. such as:
1)This power generator can be recharged from the sun with solar panel (Open circuit voltage must be 16V～68V(Max),Max 500W,solar panel not included).
2) This power station can be fully charged in 7.5-8 hrs by being plugged into the wall outlet.Charge time varies on the solar panel, eg. 2*BLUETTI SP200 Solar Panel in series: About 5-5.5Hrs.
Car recharge: you need buy a power inverter(≥300W) yourself.
Built in MPPT,no need other controller.
With a wide solar recharge range 16-60V(OCV) ,you can connect multi solar panels in series or parallel to provide Max.500W solar energy, and the pre-installed MPPT controller in the BLUETTI EB150 enable recharge the power station 40% faster. We suggest our BLUETTI SP120(120W) or BLUETTI SP200(200W) solar panel to recharge the power station.
The solar charging efficiency is much higher with MPPT built in. it can track the strength of the sunlight and adapt to the best charging mode.
Attention: the solar panel needs to be bought separately.
LCD display shows the remaining power and battery status timely. Backlight enables easy reading under the sun and will not disturb you during sleeping.
What devices can Bluetti EB150 power?
Please note that the AC output ports can only charge/power devices that operate at less than 1000-Watts, besides, the whole wattage should be under 1000 watts as well.
Once exceeding, Bluetti EB150 will shut off automatically. Please refer to your device specification before purchase.
How to figure out the recharge times of my device?
Working time = 1500Wh* 85% / rated power of your device. For reference,assuming the device features rated power 60W (might be a laptop),
working time will be 1500Wh*85% / 60w=21.3hrs (Estimated time).
Please note: actual power consumption varies from different usages.
What kind of battery cell used in the EB150 power station?
We built-in LG Li-ion battery cell,4S3P.
Can charge and discharge at the same time?
Yes, it can.
How to choose a compatible Solar panel?
It must meet:
1)Open Circuit Voltage(OCV):16-60V/Max.10A, Max.500W (DC7907 to MC4 Charging cable is included)
Tips: make sure the total OCV(open circuit voltage) is no more than 60V if you connect several solar panels in series!!
How long can be recharged by Solar panel?
It depends on the input power of the solar panel and the strength of the sunlight.
For example, for 300W input solar energy, the charge time is about 5-5.5Hrs. for a 500W solar panel, the charge time is about 3.5-4hrs.
How long should I recharge the EB150 power station if I do not use it for a long time?
We suggest recharging it every 3 or 6 months to better protect the battery cell and ensure a longer life cycle.
Can not ship to Greece.